How to license ProLink III How to license ProLink III ProLinkIII tiering introduction How do I license my Professional or Basic version of ProLinkIII? Zumba dance workout videos with latin music. Grace periods (operation without a license key) How to obtain the license key Programming the Site code & Site key Summary How to license ProLink III Program Overview ProLink III is the next generation of windows based software configuration tool for Micro Motion products. Using ProLink II Software • HART/Bell 202 connections - HART/Bell 202 connections are available on all transmitters that have an mA output, except the Model 1500 with the Filling and Dosing application. The transmitter Model 1500 with the Filling and Dosing application does not support HART communication. - HART/Bell 202 connections use standard connection parameters, so you don’t have to know the transmitter’s configuration. - Because the HART/Bell 202 connection is made over the primary mA output terminals, the communication signal can interfere with certain procedures such as loop testing, and may cause the output to change. Depending on how the primary mA output is being used, this may have significant consequences for process control. - Depending on the transmitter and wiring method, HART/Bell 202 connections may be appropriate for both temporary and permanent connections. • RS-485connections - RS-485connections are not available on all transmitters. - To use an RS-485connection, you must know the transmitter’s configuration. - RS-485connections are appropriate for both temporary and permanent connections. Making the connection 1. Ensure that your PC is connected to a transmitter, using one of the methods described in Chapter 2. If the Connect dialog box is not displayed: a. ![]() Open the Connection menu. Click on the Connect option. Select the protocol to use. Depending on the Protocol option that you choose, different communications options will be available for configuration. Note: Due to the design of HART protocol, connections made using HART protocol are slower than connections that use Modbus protocol. If you use HART protocol, you cannot open more than one ProLink II window at a time. ProLink III is the next generation of windows style software configuration tool for. Connection to all Micro Motion Coriolis transmitters AND Density & Viscosity meters. ProLink II ProLink III Basic ProLink III Professional Full Transmitter. III basic is intentionally focused on the simpler configuration and support tasks,. Micro Motion™ Coriolis Meter Verification with optional AMS. Support for multiple devices and protocols. ProLink II software (Windows XP and Vista). Note: Windows NT does not support USB connections. Note: If you are using a service port connection to a Model 1500/2500 transmitter or a Series 3000 transmitter, see Section 2.2.6 for instructions on making this connection. Specify Baud Rate, Parity, Stop Bits, COM Port, and Address/Tag as appropriate for your connection and transmitter. ![]() SeeSection 2.2.6 for more information on these parameters. Note: If you are using HART protocol and a HART tag (software tag) has been configured for your transmitter, you can specify the HART tag instead of the HART address. If you are using the Viator USB HART Interface, enable Converter Toggles RTS. Click the Connect button. Note: ProLink II can connect to only one transmitter at a time. To connect to another transmitter, you must first disconnect from the current connection. Using ProLink II Software Polling for devices If you do not know the address of your transmitter: 1.
0 Comments
Leave a Reply. |